The USB-RS485 cables are USB to RS485 levels serial converters. The cables include FTDI's FT232RL USB to serial UART interface IC
device, which handles all the USB signalling, and protocols, plus an appropriate transceiver. The cable provides a fast, simple
method to connect equipment with an RS485 interface to USB.
1.USB-RS485 converter cable provides a USB to RS485 serial interface with customised end connectors.
2.Entire USB to RS485 translation protocol handled by the electronics over-molded in the cable.
3.Overmolded FT232R chipset provides single chip USB to asynchronous serial data transfer interface. Works with all Windows and
Mac OS versions.
4.UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity.
5.Internal EEPROM with user writeable area.
6.Data transfer rates from 300 baud to 3 Mbaud.
7.Visual indication of Tx and Rx traffic via LEDs in the transparent USB connector.
8.Extended temperature range (-40°C to +85°C).
9.Electronics available as separate PCB.
Part No: USB-RS485-WE-1800-BT
USB TO RS485 WIRE END, 1.8M, BLACK, Transparent USB CONNECTOR
USB to RS485 serial interface cable
- Data Rates: 3MBaud
-
- USB Speed: Full Speed (12Mbps)
-
- Interfaces: UART
-
- USB Connector: Type A
-
- End Connector: Wire ended
-
- Cable Length: 1.8m
-
- Cable Details: 6 core, 5mm UL2464 24 AWG
-
- Packages: N/A
-
- Channels: 1
-
- I/O Voltage: RS485
-
- USB Class: FTDI Drivers
-
- Virtual Com Port: Yes
-
- Max Power Output: +5V / 250mA
-
- FTDI Internal IC: FT232R
-
- Operating Temperature: -40°C to +85°C
FTDI USB to RS485 serial UART converter cable incorporates FTDI's FT232RL USB to serial UART interface IC, which handles all the USB signaling and protocols. This FTDI converter cable provides a fast, simple way to connect devices with an RS485 interface to USB. Each FTDI USB-RS485 cable contains a small internal electronic circuit board utilizing the FT232R that is encapsulated into the USB connector end of the cable. The integrated electronics also include the RS485 transceiver plus Tx and Rx LEDs that give a visual indication of traffic on the cable. The USB-RS485 cable is designed for use at the end of an RS485 network up to approximately 10m.
- USB RS485 adapter
- USB2.0. full speed 12M support
- FT232 USB RS485 cable, signals compatible with USB-RS485-WE-1800-BT
- With 2 LEDs for data+, data- transfering
- Red-VCC(5v),Black-GND,White - Data+, Green - Data-
- FT232RL + SP485LEEN chip
- Support Android, Support Win 10, 8,8.1, Win 7, XP, 2000, Linux, Mac OS
- Integrated 1024 byte EEPROM, support Vendor ID re-write,support Mprog3.5
- Support FTDI VCP driver and D2XX driver
- Half duplex, non-isolated
- 300 ~ 1Mbps baud rate
- Up to 5km distrance transfering
- 1.8mtr in length.
- ABS USB housing, openable for testing
- 100% double test